mercator:boatyardwork
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
mercator:boatyardwork [2012/06/11 03:10] krisa [Approved Work] |
mercator:boatyardwork [2014/10/18 23:27] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Deck ====== | ||
| + | * Strip paint | ||
| + | * Strip varnish from coach-roof | ||
| + | * Remove/ | ||
| + | * Fair and fillet deck, coach-roof | ||
| + | * Fillet deck to coach-roof joints, deck to coaming joints | ||
| + | * Look at owner supplied S-1 sealer. | ||
| + | * Epoxy fill hardware fastener holes | ||
| + | * Epoxy fill engine control locations (next to tiller), controls not to be re-installed | ||
| + | * Two layers of FRP, sand, fair | ||
| + | * Fillet coach-roof to deck joint and deck to toe-rail | ||
| + | * Paint deck (cream) | ||
| + | * Sand varnish, Paint over coach-roof teak (cream) | ||
| + | * Sand varnish, Paint toe-rail (black) | ||
| + | * Sand and re-varnish coaming around cockpit area | ||
| + | * Install new self-tailing winches | ||
| + | ====== Hardware Re-Install ====== | ||
| + | * All through-bolted hardware to be installed with fitted backing plates | ||
| + | * Stantion bases and stantions | ||
| + | * Hawse-pipe | ||
| + | * Pulpits | ||
| + | * Tiller arm, base and rudder | ||
| + | * Do not use 3M 5200 | ||
| + | |||
| + | ====== Bottom ====== | ||
| + | * Two coats of ablative bottom paint | ||
mercator/boatyardwork.1339384243.txt.bz2 ยท Last modified: 2014/06/24 05:40 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
